ISRO successfully conducts autonomous landing of a space vehicle
The test was conducted at the Aeronautical Test Range (ATR), Chitradurga, Karnataka, the national agency headquartered said
The Indian Space Research Organisation (ISRO) on Sunday successfully conducted the Reusable Launch Vehicle Autonomous Landing Mission (RLV LEX).
The test was conducted at the Aeronautical Test Range (ATR), Chitradurga, Karnataka, the national agency headquartered said.
In a first in the world, a winged body has been carried to an altitude of 4.5 km by helicopter and released for carrying out an autonomous landing on a runway.
RLV is essentially a space plane with a low lift-to-drag ratio requiring an approach at high glide angles that necessitated a landing at high velocities of 350 kmph.
The RLV took off at 7:10 am IST by a Chinook Helicopter of the Indian Air Force (IAF) as an underslung load and flew to a height of 4.5 km (above Mean Sea Level).
Once the predetermined pillbox parameters were attained, based on the RLV's Mission Management Computer command, the RLV was released in mid-air, at a down range of 4.6 km.
Release conditions included 10 parameters covering position, velocity, altitude and body rates, etc.
The release of RLV was autonomous. RLV then performed approach and landing manoeuvres using the Integrated Navigation, Guidance & control system and completed an autonomous landing on the ATR airstrip at 7:40 AM IST.
The autonomous landing was carried out under the exact conditions of a Space Re-entry vehicle's landing high speed, unmanned, precise landing from the same return path as if the vehicle arrives from space.
Landing parameters such as Ground relative velocity, the sink rate of Landing Gears, and precise body rates, as might be experienced by an orbital re-entry space vehicle in its return path, were achieved.
The RLV LEX demanded several state-of-the-art technologies including accurate Navigation hardware and software, Pseudolite system, Ka-band Radar Altimeter, NavIC receiver, indigenous Landing Gear, Aerofoil honey-comb fins and a brake parachute system.
LEX utilised several indigenous systems. Localized Navigation systems based on Pseudolite systems, instrumentation, sensor systems, etc. were developed by ISRO.
Digital Elevation Model (DEM) of the landing site with a Ka-band Radar Altimeter provided accurate altitude information.
Extensive wind tunnel tests and CFD simulations enabled aerodynamic characterisation of RLV prior to the flight.
ISRO had demonstrated the re-entry of its winged vehicle RLV-TD in the HEX mission in May 2016.
The re-entry of a hypersonic sub-orbital vehicle marked a major accomplishment in developing Reusable Launch Vehicles.
In HEX, the vehicle landed on a hypothetical runway over the Bay of Bengal. Precise landing on a runway was an aspect not included in the HEX mission.
The LEX mission achieved the final approach phase that coincided with the re-entry return flight path exhibiting an autonomous, high-speed (350 kmph) landing.
The LEX began with an Integrated Navigation test in 2019 and followed multiple Engineering Model Trials and Captive Phase tests in subsequent years.
Along with ISRO, IAF, Centre for Military Airworthiness and Certification (CEMILAC), Aeronautical Development Establishment (ADE), and Aerial Delivery Research and Development Establishment (ADRDE) contributed to this test.
The IAF team hand in hand with the Project team and multiple sorties were conducted to perfect the achievement of release conditions. Secretary in the Department of Space and ISRO Chairman S Somanath was among those who witnessed the test.